Bluetooth Initialization; Telemetry Data Display; Sensors - GRAUPNER mc-32 HoTT Manual

Bluetooth initialization

Telemetry data display

Sensors

33032_jp_V1
cyclically select the positions of the four calibrated sticks.
Touching the ESC key will terminate the process and return to
the sub-menu "Stick cali.".
Example: Bring here the respective left blinking selection arrow
of the right stick to the left limit. Tip on the SET key. So the cal-
ibration of the right stick left limit. The circle in the middle of the
stylized stick blinks as confirmation.
Leave the self neutralizing stick, so that it can reach its neutral
position and push the SET key to calibrate the neutral position.
Calibration options:
The calibration options of these five proportional controls are
available ofter pushing the selection keys
touch pad so oft, till you arrive to the desired calibration option,
e. g. like the picture on the left.
In this display you can initialize an optional Bluetooth module fol-
lowing the manual included in the module package content.
Any combination of to four sensors can be connected to a
receiver that operates by telemetry.
The display is used for operating the transmitter and to graphi-
cally display telemetry data. The change between these two use
mode is carried out through the selection keys
left touch pad in the main display.
So appear the telemetry display. By tipping again the selection
keys , you can select which sensor or module you want to be
displayed.
If instead there are two "X"
and it appears the message "CAN'T RECEIVE ANY DATA", it
means that there is no connection between receiver and trans-
mitter and that no telemetry data is available. Turn on your
receiver, or bind a receiver to the active model memory.
or of the right
or
in the lower part of the display
of the
31 / 36