We’ll share your photos and videos with our global audience (seriously we will). Temperature settings / p 9 Puffco Battery / p 9 Cleaning your device / p 10 Advanced features / p 11 Warning / p 11 Peak Protection / p 12...
WHAT’S INSIDE: QUICK START: STEP 1: Fully charge device before first use. Device pulses white while charging, and turns off automatically when complete. A: Loading tool F: Carb cap* B: Cotton swabs G: Atomizer cover C: USB cable H: Ceramic bowl (2) I: Atomizer D: AC adapter STEP 2: Fill glass with water just above the...
Page 4
STEP 3: Carefully push glass into the base. STEP 5: Single click to toggle through heat settings. Align inlet hole on the front of the glass ( ) BLUE (Small load) / 450 ° - GREEN (Medium) / 500 ° with atomizer.
Page 5
STEP 7: Place carb cap on top of atomizer. STEP 9: Device will vibrate and lights will flash when ready. Inhale repeatedly until device is finished producing vapor. *See p. 11 for sesh mode. STEP 10: Use a cotton swab to clean STEP 8: Double click to initiate heat-up (20 second the chamber after each use.
(Large load) / 550 ° > 25 sec. heat up PEAK (XL load) / 600 ° > 25 sec. heat up The Peak device features intelligent temperature calibration, which provides a more consistent experience during repeated use. This means that all heat up times vary.
ADVANCED FEATURES: Sesh Mode: Haven’t reached your peak? We got you covered. We created a sesh mode that increases heat and extends your session by 15 seconds. Use it to boost - P U F F C O Q U A L I T Y G U A R A N T E E - heat, or to share with your friends.
Page 8
Know that Puffco reserves the right to verify the age of the consumer prior to every purchase. Registered Puffco products are not intended for any use which is illegal under any state or federal law.
Page 9
13-352-11111 by Puffco Creation Labs - Subject to alterations · All rights reserved...
Need help?
Do you have a question about the PEAK and is the answer not in the manual?
Questions and answers