Honeywell 6824 User Manual page 77

Set Right Margin
Description:
Decimal:
Hex:
ASCII:
Notes:
Set Left Margin
Description:
Decimal:
Hex:
ASCII:
Notes:
Set Skip Over Perforation
Description:
Decimal:
Hex:
ASCII:
Notes:
6824 Mobile Full Page Printer User Manual
Sets the right margin to n columns using the current character pitch, and clears all text
in the print buffer. This is the number of the characters from column 1 (at the left edge
of the paper) to the last column before the right margin (factory default is 80).
Minimum space between margins is the width of one double-width pica character.
Maximum value for this control code is the maximum number of characters (based on
the current pitch) that would fit between the left margin and the right edge of the default
printable area of the page.
Valid ranges for n are as follows:
•
Pica mode: 2 to 80
•
Elite mode: 2 to 96
•
Compressed mode: 2 to 136
27 81 n
1B 51 n
ESC "Q" n
Ranges may vary, depending on values of other parameters that affect character width.
If the value specified is not within the allowed range, the value is ignored.
Clears the print buffer text and sets the left margin, relative to the number of columns to
the left of the first column to print (factory default = 0).
Minimum space between margins is the width of one double-width pica character.
Maximum value must be less than the right margin.
Valid ranges for n are as follows:
•
Pica mode: 0 to 78
•
Elite mode: 0 to 93
•
Compressed mode: 0 to 133
27 108 n
1B 6C n
ESC "l" n
Ranges may vary, depending on values of other parameters that affect character width.
If the value specified is not within the allowed range, the value is ignored.
Defines the number of lines to skip between the last printed line on the page and the
first printed line on the next page. If the value specified for this function is greater than
the page length, it is ignored. Cancel this function by using one of the Set Page Length
functions (factory default is disabled). The amount of blank space at the bottom of the
printed page depends on the line spacing.
27 78 n
1B 4En
ESC "N" n
This function is valid for continuous paper only.
Appendix B – Printer Control Codes
67