Indicator Lamp In The Charging Station - Husqvarna AUTOMOWER 440 Operator's Manual

Message Cause
SMS could not be
Poor GSM coverage or maximum number of
sent
SMS reached. Maximum 10 SMS per month
can be sent to the mower. No funds left on
SIM card.

6.4 Indicator lamp in the charging station

For a fully functional installation, the indicator lamp in the charging station must emit a solid or flashing green light. If
something else appears, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
Light Cause
Solid green light
Good signals
Green flashing light
The signals are good and
vated.
Blue flashing light
The boundary loop is not connected to the
charging station.
Break in the boundary loop.
Red flashing light
Interruption in the charging station's antenna. Contact your local Husqvarna representative.
Solid blue light
Weak signal as the boundary wire is too long.
Max length is 800 meters.
Solid red light
Fault in the circuit board or incorrect power
supply in the charging station. The fault
should be rectified by an authorized service
technician.
54 - Troubleshooting
Action
In case of persisting problems, get in touch
with your local Husqvarna representative.
Action
No action required
ECO mode is acti-
No action required. For more information on
ECO mode , see ECO mode on page 33 .
Check that the boundary wire connectors are
fitted properly to the charging station. See
Connecting the boundary wire on page 19 .
Find out where the break is. Replace the
damaged section of the loop with a new loop
wire and splice using an original coupler.
No steps have to be taken if the robotic lawn-
mower operates as expected.
Shorten the boundary wire by reducing the
working area or replacing islands with barri-
ers the robotic lawnmower can collide with.
Contact your local Husqvarna representative.
447 - 001 -