Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Smittybilt X20 10,000LB
Summary of Contents for Smittybilt X20 10,000LB
- Page 2 X2O Winches...
- Page 3 NEVER operate winch with less than 10 wraps of rope around the drum. The terminal end is to prevent the rope from unraveling, it is NOT a load bearing attachment point. Improper installation and / or spooling out to last layer will put a load on the terminal end and the rope will release from the terminal.
- Page 4 6 wraps of steel cable or 10 wraps of synthetic rope remain on the winch drum when this mark appears at the rollers. No recovery should be attempted beyond this marking. wraps of steel cable or 10 wraps of synthetic rope minimum on the drum. If this is not pra- tical use a snatch block and double line arrangement.
- Page 5 17. Do not attempt to exceed the pulling limits of this winch. 18. Do not drive your vehicle to assist the winch in any way. Vehicle movement in combi- 19. Shock loads when winching are dangerous! A shock load occurs when an increase force...
- Page 9 Control box can sit anywhere over the drum, determine best location for you.(left, center, right) Secure by tightening the screw on the rear of each bracket and add lock nut Step 2: Determine where you want control box over the drum (left, center, right), then secure using the included screw, L bracket, nut on the rear.
- Page 10 Wireless remote will automatically turn "OFF" after two minutes of non-operation. Remote cannot be submerged leftward rightward It is recommended that for the initial set-up of the winch (prior to applying any load) that the winch be operated in the WIRED mode. Once the winch has been set-up then the remote hand control can be operated either in the WIRED OR WIRELSS mode.
- Page 11 A. Do not use as a hoist B. Power out only to relieve slack on cable or rope. Excessive powering out can cause damage to internal components. C. Do not use to hold loads D. Do not use to drop loads (example-unloading vehicles)
- Page 16 Motor Housing “Clocking” Motor Housing Step 1: Loosen and remove the 4 Step 4: Rotae the motor to the optimal mator bracket bolts position needed. Step 2: Remove the motor cover Step 5: Re-install the 2 long bolt on the motor end cap Step 3: Loosen and remove the 2 Step 6: Re-install the 4 motor long bolts on the motor end cap...
- Page 17 Remote battery replacement It is recommended that for the initial set-up of the winch (prior to applying any load) that the winch be operated in the WIRED mode Once the winch has been set-up then the remote hand control can be operated either in the WIREED or WIRELESS mode To use the remote hand controller in the WIRELESS mode remove the control cable from the control box, unplug the remote hand controller from the control cable and...
- Page 18 Wireless Receiver Replacement Step 1: Remove the control box mount brackets (if attached) then remove the four small phillips screws in order to remove the box cover. (Fig A2) remove cover carefully. Step 2: With care pull receiver off of base. (Fig B2) (Fig A2) (Fig B2) Step 3:...
- Page 21 7/16...
Need help?
Do you have a question about the X20 10,000LB and is the answer not in the manual?
Questions and answers