Terminal Function Keys - Ingenico IWL 250 User Manual

1.3 Terminal Function Keys

Figure 2
SecureTablePay Screen
TID 123
SWIPE/KEY SERVER
Terminal Dimensions: 6.5 (l) x 2.1 (H) x 3.1(W) inches [165 (l) x 54 (H) x 78 (W) mm]
Terminal Weight: 10 oz. (300g)
2
DRAFT
When the Terminal starts up, it will show the
SecureTablePay version screen (Figure 2).
TID 123: This is the 8-digit Terminal identification number.
SWIPE/KEY SERVER: This is a prompt for the Server to
log on to the payment system by either:
• Swiping their ID Card at the right side of the Terminal.
• Inserting their ID Card at the bottom of the Terminal.
• Key in their identification PIN code on the Terminal
Keypad. Press the Green Enter key at the bottom,
right of the keypad to continue.
Figure 3
Function Keys
• Main Function F-Key (above the Red Cancel key)
‒
Press to access, example: Stand-Alone state or
SecureTablePay.
• Red Cancel key (bottom, left of keypad).
‒
Press to back out of or stop a keypad entry.
• Yellow Correction key (bottom, middle of keypad).
‒
Press to remove a key entry.
• Green Enter key (bottom, right of keypad).
‒
Press to continue a selection.
Secure Table Pay Terminal User Guide
Up/Down Arrow Buttons

F1 F2 F3 F4
V1.0