Changing The Terminal Date And Time - Ingenico IWL 250 User Manual

Press 2 for System Setup.
Screen: ADMIN PASSWORD + OK
Enter the Admin Password: defaulted to 6 zeros: 000000 and press the Green Enter key.

2.2.1 Changing the Terminal Date and Time

NOTE: The Batch must be cleared to change the date and time or, they will not display.
If necessary, the Batch can be cleared by going to STANDALONE\Setup\5. HELP DESK\2.
CLEAR BATCH. WARNING:
received all transactions first.
Screen: TERMINAL DATE (YYYYMMDD) + OK
Enter the current date as the full year, month number, day and press the Green Enter key.
Press the Green Enter key to continue if the date is already set and acceptable.
Press the Red Cancel key to exit.
Screen: TERMINAL TIME (HHMM) + OK
100 Hours Military Time
Time entries are in 100 hours or Military Time.
Refer to the following table for the time values to enter.
AM 100 Hours
12:00
00:00
(Midnight)
1 01:00
2 02:00
3 03:00
4 04:00
5 05:00
Enter the current time as the hour and minute and press the Green Enter key.
Press the Green Enter key to continue if the time is already set and acceptable.
Press the Red Cancel key to exit.
The date and time will display in the
Terminal Status Bar, above the screen.
Continued after Date and Time settings if they display in System Setup:
Screen: 1. DNS SETUP 2. TERMINAL SETUP
Press 1 for DNS Setup.
Screen: AUTOMATIC DNS YES
NO YES
Press the F1 key under NO or the F4 key under YES and press the Green Enter key.
If the setting is already done and acceptable, press the Green Enter key to continue.
Press 2 for Terminal Setup.
V1.0 DRAFT
Clearing the Batch will delete all transactions. Confirm the Host
AM 100 Hours
6 06:00
7 07:00
8 08:00
9 09:00
10 10:00
11 11:00
Terminal
Bluetooth
Comms
Secure Table Pay Terminal User Guide
PM 100 Hours
12:00
12:00
(Noon)
1 13:00
2 14:00
3 15:00
4 16:00
5 17:00
Network
Connection
TID 123
PM 100 Hours
6 18:00
7 19:00
8 20:00
9 21:00
10 22:00
11 23:00
3: 5
Time
Date
02/16/2017
Battery
15