Kenwood DDX795 Instruction Manual page 67

Installation and Connection Installation and Connection
For DMX718WBTL
STEERING
REMOTE
10 A fuse
¥
Blue with white stripe
(12 V 350 mA)
P.CONT
Brown
MUTE
Å *
ANT CONT
C5
A
Antenna cord: Connect to the antenna terminal.
D22
D21 D23
«
[
Connect the antenna cord from the power cord (A) to the antenna
terminal.
Purple with white stripe
Light green
USB input terminals (1 m)
To the control terminal of the motor antenna or to the power terminal for
the booster amplifier of film-type antenna
Not used.
Connector B: To the car's harness
Connector A: To the car's harness
Connector C: To the car's harness
Connector D: To the car's steering remote harness
• Depending on the type of vehicle, it cannot be
connected.
To the car's reverse lamp harness when using the optional rear view camera
REVERSE
PRK SW
Extension wire ( ø )
Pin
A1
A2
A3
A4
A
A5
A6
A7/A8 White with black stripe
A9/A10 Gray with black stripe
B1/B2 Green with black stripe
B
B5/B6 Purple with black stripe
C C5
D21
D D22
D23
* When using Antenna Control, connect the ANT CONT lead (blue)
to A5 (blue) on the wiring harness.
To the car's parking brake detection switch harness
(For best safety, be sure to connect the parking
sensor.)
Color and Function
Orange/White: Dimmer
Yellow: Battery
Blue: Antenna control
Red: Ignition (ACC)
Blue: Antenna control
Black: Ground connection
[ ]
/ White : Left speaker (front)
[ / Gray ] : Right speaker (front)
[ ]
/ Green : Left speaker (rear)
[ / Purple ] : Right speaker (rear)
Blue: Antenna control
White: Input 1
Red: Input 2
Black: Ground
ENGLISH 65