Panning A Graphical Representation - Siemens SINUMERIK 840D sl Operating Manual

Simulating machining
7.8 Modifying and adapting the simulation graphics
Note
Selected section
The selected sections and size changes are kept as long as the program is selected.
7.8.2

Panning a graphical representation

Precondition
The simulation or the simultaneous recording is started.
Procedure
7.8.3 Rotating the graphical representation
In the 3D view you can rotate the position of the workpiece to view it from all sides.
Requirement
The simulation or simultaneous recording has been started and the 3D view is selected.
184
Press the "Details" and "Zoom -" softkeys if you wish to decrease the size
of the segment.
- OR -
Press the "Details" and "Auto zoom" softkeys if you wish to automatically
adapt the segment to the size of the window.
The automatic scaling function "Fit to size" takes account of the largest
expansion of the workpiece in the individual axes.
1. Press a cursor key if you wish to move the graphic up, down, left, or right.
Operating Manual, 05/2017, A5E40868517
Universal