Dismantling The Tooling And Replacing Spare Parts - SM CONTACT SM CRIMP 2000 Operator's Manual

NOTICE SM CRIMP 2000-V8.0 / Mai 2012

5 DISMANTLING THE TOOLING AND REPLACING SPARE PARTS

The names of the spare parts that constitute the tooling:
5.1 Opening the tooling
 Place the tooling onto a clean surface.
 When handling the tooling, be careful not to
damage the finger guard.
 Loosen the screw of the cutting block.
 The screw should be placed 8 to 10 mm above the
face of the tooling.
 Push the cutting block slightly sideways with small
screwdriver.
1
K
1
Contact sonde
K
16