Energy-saving radiator thermostat with z-wave (20 pages)
Summary of Contents for Eurotronic Spirit Z-Wave Plus
Page 1
„Made in Germany”. Warning / Safety Please consult this Quick Start Guide User Manual for all questions related the Spirit Z-Wave Plus radiator Thermostat. Introduction Spirit Z-Wave Plus Please read this User Manual carefully before installing the Spirit Z-Wave Plus thermostat and store Controls-/ Display elements this manual for documentation.
• Operate Spirit Z-Wave Plus only as described in the user manual. • Spirit Z-Wave Plus should only be put to use in a dry and dust-free place, away from direct sunlight. • Screw Do not keep using the device when there is obvious for adapter damage.
Page 3
Lights up if less than 15% battery is remaining. Lights up if child protection is set. Displayed if the LCD shows a setpoint temperature. Displayed instead of °C Icon if the Spirit Z-Wave Plus is set to direct control mode.
Page 4
Set your primary Z-Wave Controller to inclusion mode and the batteries. Pay attention to the correct polarity! At a later follow the steps. battery change, the configuration of your Spirit Z-Wave Plus is maintained. Inclusion mode (Inclusion) is displayed Press Boost-Button Display shows Node-ID ...
Page 5
INSTALLATION AT THE RADIATOR Installation at the radiator with Adapter Ventil – Adapter – Spirit Z-Wave Plus After succesful inclusion the display showsINS and the button is green blinking (don‘t press it yet). Follow the steps for instal- lation. Installation at the radiator without Adapter Valve Adapter –...
Boost/Okay Hold for 3 seconds The LCD shows the Z-Wave Node ID. Boost/Okay Hold for 5 seconds The Spirit Z-Wave Plus will react to Inclusion/Exclusion Commands. Boost/Okay Hold while unpowered and Allows factory reset of the Spirit Z-Wave Plus. insert batteries...
Page 7
ADAPTERS REMOVING WARNING Exclude the Spirit Z-Wave Plus from the network before Remove the connecting pieces of the plastic adapter com- removing. Set Z-Wave Controller in Exclusion mode. Hold the pletely before you use one of the supplied adapter! boost button for at least 5 seconds to exclude. When this process finished,INC is again on the display.
Page 8
Pressure Due to an Put in the pressure HELP AND ERROR MESSAGES piece falls endless thread piece. The device can out (This the pressurepiece, be adapted by removing and can also which is situated inserting the batteries. The Error Cause Solution cause an at the bottom,...
Page 9
Hereby, EUROtronic Technology GmbH declares that the for the use of the following valves: Heimeier, Junkers Lan- Spirit Z-Wave Plus Radiator Thermostat is in compliance dys + Gyr, MNG, Honeywell, Braukmann (measure of thread with Directive 2014/53/EU. The full text of the EU decla- M30 x 1,5), Oventrop (M30 x 1,5) Danfoss RA, RAV and RAVL.
Page 10
Technical modifications are subject to change. All descriptions for compatibility are without engagement. EUROtronic Technology GmbH Südweg 1 | 36396 Steinau-Ulmbach Telefon: +49 (0) 66 67 / 9 18 47-0 E-Mail: info@eurotronic.org | Internet: www.eurotronic.org Verp.-Nr. 601048-01 | Stand: 2017/10...
Need help?
Do you have a question about the Spirit Z-Wave Plus and is the answer not in the manual?
Questions and answers