Removing Ego Windshield Sticker Tags - TransCore encompass 4 User Manual

Reader system
Hide thumbs Also See for encompass 4:
Table of Contents

Advertisement

Encompass 4 Reader System Guide

Removing eGo Windshield Sticker Tags

Installing eGo LPT
Installing Interior ATA Tags
3-18
2.
Thoroughly clean the interior surface of the windshield behind and around the
rearview mirror where the tag will be located.
3.
Dry the tag location area thoroughly using a clean, dry cloth.
4.
Remove the paper backing from the tag to expose the adhesive.
Caution
Ensure that the tag is correctly located before touching it to the glass. Once the
sticker tag is applied to the glass, it cannot be moved without damage to the tag.
5.
Holding the sticker tag by its edges, position the tag in the correct area of the
windshield (determined in Step 1), making sure the tag is oriented horizontally
and is at least two inches (5 cm) from the windshield frame and 0.75 inch (1.9
cm) from the mirror post.
6.
Press the sticker tag firmly against the glass and gently rub over the entire tag
surface. Ensure that no air bubbles remain between the sticker tag and the
windshield.
Removing eGo WSTs requires the use of a plastic scraper or equivalent tool. The tag
is inoperable once removed.
Follow the instructions presented in
installing an eGo LPT.
Interior ATA-protocol tags are installed using hook-and-loop material or double-sided
tape attached to the tag and to the windshield. When using hook-and-loop material,
the loop material should be applied to the back of the tag and the hook material should
be applied to the windshield. After the tag is installed, it can be removed easily and
used in any vehicle that has corresponding hook material affixed to the windshield.
Note: Installing interior tags using double-sided tape results in a semipermanent
attachment; the tag will be more difficult to remove than one installed using hook and
loop material.
Interior ATA-protocol tags may be ordered from the factory with hook-and-loop
material or double-sided tape already applied to the tag. The adhesive on this material
is specially formulated for temperature extremes inside vehicles.
"eGo Plus License Plate Tag" on page 3-5
when

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the encompass 4 and is the answer not in the manual?

Questions and answers

Table of Contents

Save PDF