Installing Ego Plus Security Sticker Tags - TransCore encompass 4 User Manual

Installing eGo Plus Security Sticker Tags

An eGo Plus Security Sticker Tag is located in the same area on the windshield as the
eGo Plus Sticker Tags. See
information. The eGo Plus Security Sticker Tag is slightly less flexible than the eGo
Plus Sticker Tag so the installation instructions differ. Detailed instructions for install-
ing the eGo ® Plus Security Sticker Tag are found in the pocket guide "Quick and Easy
Installation Instructions for the eGo
eGo Plus Security Sticker Tag Installation Procedures
Caution
Confirm that the outside temperature is above 50°F (10°C). The security sticker tag
may not adhere correctly if the temperature is below this temperature.
To install the eGo Plus Security Sticker Tag
1. Determine the tag installation location for the vehicle using the placement
guidelines in the section
2. Thoroughly clean the interior surface of the windshield behind and around the
rearview mirror where the tag will be located.
3. Dry the tag location area thoroughly using a clean, dry cloth.
4. Remove the backing from the tag to expose the adhesive.
Caution
Ensure that the tag is correctly located before touching it to the glass. Once the
security sticker tag is applied to the glass, it cannot be moved without damage to the
tag.
5. Holding the sticker tag by its edges
area of the windshield (determined in Step 1), making sure the tag is oriented
horizontally and is at least two inches (5 cm) from the windshield frame and 0.75
inch (1.9 cm) from the mirror post.
Choosing, Installing, and Removing Tags
"Positioning eGo Plus Sticker Tags" on page 3-8
® Plus Security Sticker Tag."
"Positioning eGo Plus Sticker Tags" on page
(Figure 3-11), position the tag in the correct
for this
3-8.
3-11