Samsung CLP-300 Remanufacturing Instructions page 4

8. Clean the inside of the cartridge thoroughly using
compressed air or a vacuum. With a half -inch hole, it would be
much easier to just vacuum it out and is much less messy. We
always recommend using compressed air, but in tight
situations like this, it's best to vacuum. A vacuum will also be
better at getting any plastic shavings that may have fallen
inside.
10. The next step is covering the hole using an adhesive
hopper fill plug (shown) or sealing tape. Make sure you have a
tight seal around the hole to prevent any toner from leaking
out.
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
SAMSUNG CLP-300 • TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
9. Insert a funnel through the hole. Be sure to shake the toner
bottle well before opening. Pour the appropriate amount of
toner via the funnel.
www.uninetimaging.com