Advertisement
References for Installation
Loading Configuration Data and Measuring the RSL
Open the maintenance compartment.
If a Wi-Fi module is installed at the USB port, you can determine whether the Wi-Fi module is working properly
by enabling it to search for the SSID of an NE in the wireless LAN. If the SSID can be searched out, the Wi-Fi
module is working properly. If the SSID cannot be searched out, open the maintenance compartment and view
the Wi-Fi module indicator. If the indicator is steady red, replace the Wi-Fi module.
Verifying the Installation
Verify that RTN 360s are installed in planned locations and sufficient space is reserved
1
for maintenance.
Verify that RTN 360s are securely installed by turning the boxes gently (in both the
2
horizontal and vertical directions).
Verify that OT terminals of PGND cables are tightly crimped and PGND cables are not
3
damaged or broken.
4
Verify that PGND cables are bound separately from other cables.
Verify that the protection ground of an RTN 360 shares the same ground bar with the
5
lightning protection ground of the building bearing the RTN 360.
Verify that shielded RJ45 connectors of outdoor network cables are intact and tightly
6
crimped and the cables are not damaged or broken.
Verify that PG covers are tightly screwed onto the network ports of RTN 360s, unused
7
ports are protected with caps, and removed caps are retained for future use.
Verify that outdoor network cables are routed along planned paths and bound properly
and neatly at equal intervals (about 1 meter), and the excess of each cable tie is cut off
8
without leaving sharp edges.
9
Verify that alignment scopes are removed and kept secure.
20/21 >>
Load configuration data.
USB flash drive
Web LCT
Measure the RSL.
RSL tester
If the RSL is lower than the required value, re-align the
RTN 360 pair.
Close the maintenance compartment.
Advertisement
