Table of Contents
Advertisement
cf ba=en
cf chip=3042
cf clk=ext
cf dbc=en
cf drst=dis
cf mode=7
cf nmi=en
cf rrt=en
cf rsp=9
cf tdma=en
cf trfsh=en
cf trst=en
bc -d bp #disable
bc -e rom #enable
bc -d bnct #disable
bc -d cmbt #disable
bc -d trig1 #disable
bc -d trig2 #disable
2-10 Getting Started
For example, if you have the following configuration items
displayed (those in bold indicate items different from the list
above):
To make these configuration values agree with the desired
values, type:
R> cf clk=int
R> cf rrt=dis
3. Now, you need to set up stack pointer.
Type:
R> cf rsp=0ff904
4. Let's go ahead and set up the proper break conditions.
Type:
R> bc
You will see:
For each break condition that does not match the one listed,
use one of the following commands:
To enable break conditions that are currently disabled, type:
R> bc -e <breakpoint type>
To disable break conditions that are currently enabled, type:
R> bc -d <breakpoint type>
For example, if typing bc gives the following list of break
conditions:
Advertisement
Table of Contents
