Related Manuals for Stelpro ORLEANS SORB Series
Summary of Contents for Stelpro ORLEANS SORB Series
- Page 1 USER’S GUIDE SORB SERIES HIGH-END FAN HEATER REPLACEMENT COMPONENT LIST INCLUDED For further information or to consult this guide online, please visit our website at www.stelpro.com INSSORB1017...
-
Page 2: Important Instructions
If needed, speak with a specialist (industrial and commercial buildings) who will be able to calculate these heat losses and optimize the required capacity or consult the “Calculation Tools/Heating Calculator” section of the °STELPRO Design website. - Page 3 INSTALLATION Cut off power supply at circuit breaker or fuse before proceeding to the installation. Use the appropriate screw sets (minimum head diameter 1/4 in (6.5 mm)) and anchors according to the wall type and the weight of the product (10 lbs). When drilling into the wall, make sure not to damage the electrical wiring and other hidden utilities.
-
Page 4: Operation
OPERATION WITH A WALL-MOUNTED THERMOSTAT Choose a thermostat equipped with a TRIAC, which makes it possible to maintain a precise temperature, thus increasing your level of comfort. WITH A BUILT-IN ELECTRONIC THERMOSTAT FOR SMART HOMES DISPLAYED ITEM LISTING Zigbee connectivity status ( Ambient room temperature (or the temperature setpoint, if the display is flashing). - Page 5 BUTTON FONCTIONS BUTTONS MAIN SCREEN ADVANCED MENUS UP BUTTON OR DOWN BUTTON Set the temperature setpoint* Browse and edit settings Select and confirm BOOST setting BOOST BUTTON Activate/deactivate BOOST mode (in the BOOST menu) UP AND DOWN BUTTONS SIMULTANEOUSLY FOR 3 SECONDS Access advanced menus Exit advanced menus BOOST BUTTON FOR 3 SECONDS...
- Page 6 °STELPRO MENU UNIT OVERHEAT DETECTION Information about the unit is available in the advanced menus. This unit can detect when it is overheating. Follow these steps to access this information: If your unit’s thermal protection gets activated, an icon will flash on the display.
-
Page 7: Troubleshooting
TROUBLESHOOTING PROBLEM DEFECTIVE PART OR PART TO CHECK • Open circuit breaker or fuse The unit does not work • Faulty connections • Defective thermostat • Heat losses greater than the unit capacity The unit runs continuously • Temperature setpoint is set too high •... - Page 8 FRONT COVER ST-291 THERMOSTAT (SORB2002W MODEL) CIR-051 THERMOSTAT POWER SUPPLY (SORB2002W MODEL) SWI-051 SWITCH (SORB2002WCW MODEL) M-SORB11ZW2 SLEEVE S-050/10/QT/MS FACADE SCREWS: MECANICAL SCREW, BUTTON HEAD, QUADREX, 1/2 in, 10-24 STELPRO DESIGN INC. | Saint-Bruno-de-Montarville | Québec | J3V 6L7 INSSORB1017...
-
Page 9: Limited Warranty
Moreover, it does not cover the cost of disconnection, transport, and installation. The warranty is limited to the repair or the replacement of the unit or the refund of its purchase price, at the discretion of °STELPRO. Any parts replaced or repaired within the warranty period with the written authorization of °STELPRO will be warranted for the remainder of the original warranty... - Page 10 INSTRUCTIONS TO REMOVE THE FRONT PANEL 1. Remove the screw. 2. Remove the front panel by pulling and pushing it up. INSSORB1017...
Need help?
Do you have a question about the ORLEANS SORB Series and is the answer not in the manual?
Questions and answers