Asko HIG1944MD Instructions For Use Manual page 31

FAULTS
Symptom
A cooking zone suddenly
stops working and you hear
a signal.
The hob is not working
and nothing appears in the
display.
A fuse blows as soon as the
hob is switched on.
'br' appears in the display
and the controls do not
respond.
Error code F00/the red light
next to the child lock button
is lit and the light above the
pause button is flashing.
Error codes F0 to F6 and FC.
Error code F7.
Error codes F8 and F08/the
red light next to the child
lock button is lit and the light
above the pause button is
flashing.
Error code F9 and/or
continuous audio signal.
Error code F99/the red light
next to the child lock button
is lit and the light above the
pause button is flashing.
Error code FA.
Error code FAN.
Other error codes.
Possible cause
The preset time has ended.
There is no power supply
due to a defective cable or a
faulty connection.
The appliance is incorrectly
connected.
The bridge function is
switched on.
The control panel is dirty or
has water on it.
Defective generator.
The ambient temperature is
not good.
Appliance overheated.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
2 or more buttons are being
operated simultaneously.
Mains voltage is too low.
Air circulation not good.
Solution
Switch off the signal by
pressing the - or + button on
the timer.
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
Switch off the bridge function
(see page 21).
Clean the control panel.
Please contact your service
centre.
Switch off all heat sources
in the vicinity of the cooking
plate.
Let the appliance cool down
and start cooking again.
Have your connection
changed.
Do not operate more than 1
button at a time.
Contact your energy
supplier.
Make sure the venting holes
under the cooking plate are
open.
Please contact your service
centre.
EN 31