Interlocks And Relays - Poulan Pro Poulan XT PXT12530 Operator's Manual
Poulan lawn tractor operator's manual
Hide thumbs
Also See for Poulan XT PXT12530:
- Parts manual (20 pages) ,
- Operator's manual (28 pages) ,
- Operator's manual (29 pages)
Table of Contents
Advertisement
SERVICE AND ADJUSTMENTS
REPLACING BATTERY (See Fig. 34)
WARNING: Do not short battery ter mi -
nals by allowing a wrench or any other
object to contact both terminals at the
same time. Before connecting battery,
remove metal bracelets, wristwatch
bands, rings, etc. Positive terminal
must be connected first to prevent
sparking from ac ci den tal grounding.
•
Lift seat pan to raised position.
•
Disconnect BLACK battery cable first then RED battery
cable and carefully remove battery from tractor.
•
Install new battery with terminals in same position as
old battery.
•
First connect RED battery cable to positive (+) terminal
with bolt and nut as shown. Tighten securely. Slide
terminal cover over terminal.
•
Connect BLACK grounding cable to negative (-) ter -
mi nal with remaining bolt and nut. Tighten se cure ly.
•
Lower seat pan.
SEAT PAN
TERMINAL
COVER
POSITIVE
(RED)
CABLE
02603
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
•
Check wiring. See electrical wiring diagram in the Repair
Parts manual.
TO REPLACE FUSE
Replace with 20 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
02602
NUT
BOLT
NEGATIVE
(BLACK)
Fig. 34
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 35)
•
Raise hood.
•
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
•
To replace, reverse above procedure.
ENGINE
CABLE
TO AD JUST THROTTLE CON TROL CABLE
The throttle control has been preset at the factory and
ad just ment should not be necessary. If adjustment is nec-
es sary, see engine manual.
TO AD JUST CHOKE CON TROL
The choke control has been preset at the factory and ad just-
ment should not be necessary. If adjustment is necessary,
see engne manual.
TO ADJUST CARBURETOR
Your carburetor is not adjustable. If your engine does not
operate properly due to suspected carburetor problems,
take your tractor to an authorized service center for repair
and/or adjustment.
23
02495
HOOD
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Poulan XT PXT12530 and is the answer not in the manual?
Questions and answers
How do I start it
To start the Poulan Pro XT PXT12530:
1. Move the throttle control to the choke position.
2. Insert the key into the ignition.
3. Turn the key clockwise to the "START" position and release it as soon as the engine starts. Do not run the starter for more than 15 seconds per minute.
4. If the engine does not start:
- Move the throttle to the fast position, wait a few minutes, and try again.
- If it still doesn't start, move the throttle back to choke and retry.
For warm weather starting (50°F and above):
- Once the engine starts, move the throttle to the fast position.
- The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and let it warm up.
This answer is automatically generated