Poulan Pro Poulan XT PXT12530 Operator's Manual
Poulan lawn tractor operator's manual
Hide thumbs
Also See for Poulan XT PXT12530:
- Parts manual (20 pages) ,
- Operator's manual (28 pages) ,
- Operator's manual (29 pages)
Table of Contents
Advertisement
IMPORTANT MANUAL
OPERATOR'S MANUAL
MODEL:
PXT12530
LAWN TRACTOR
ALWAYS WEAR EYE PROTECTION DURING OPERATION
Visit our website: www.poulan-pro.com
429078
06.08.09 AP
DO NOT THROW AWAY
WARNING:
Read this Man u al and follow all Warnings
and Safety Instructions. Fail ure to do so
can re sult in serious in ju ry.
Printed in the U.S.A.
Advertisement
Table of Contents
Related Manuals for Poulan Pro Poulan XT PXT12530
Summary of Contents for Poulan Pro Poulan XT PXT12530
- Page 1 IMPORTANT MANUAL OPERATOR'S MANUAL MODEL: PXT12530 LAWN TRACTOR ALWAYS WEAR EYE PROTECTION DURING OPERATION Visit our website: www.poulan-pro.com 429078 06.08.09 AP DO NOT THROW AWAY WARNING: Read this Man u al and follow all Warnings and Safety Instructions. Fail ure to do so can re sult in serious in ju ry.
-
Page 2: Safety Rules
Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. WARNING: In order to prevent ac ci den tal starting when setting up, trans port ing, ad just ing or making repairs, al ways dis con nect spark plug wire and place... -
Page 3: General Service
Safe Operation Practices for Ride-On Mowers III. CHILDREN Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the ma chine and the mowing activity. Never assume that children will remain where you last saw them. •... -
Page 4: Table Of Contents
Gasoline Capacity 1.5 Gallons And Type: Unleaded Regular Oil Type (API: SF-SJ): SAE 30 (Above 32°F) SAE 5W-30 (Below 32°F) Oil Capacity: 48 Oz. Spark Plug: Champion RC12YC (Gap: .030") Ground Speed (Mph): Forward: Reverse: Charging System: 3 Amps Battery 5 Amps Headlights Battery: Amp/Hr:... -
Page 5: Unassembled Parts
UNASSEMBLED PARTS Steering Wheel Insert Steering Wheel Adapter (1) Seat Key(s) Steering Wheel Flat Washer Steering Wheel (1) Hex Bolt Steering Boot Seat (1) Washer (1) Knob (1) Oil Drain Tube For Future Use (1) Lock Washer (1) Large Steering Extension Shaft Slope Sheet... -
Page 6: Assembly
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. -
Page 7: Check Tire Pressure
INSTALL SEAT (See Fig. 3) Adjust seat before tightening adjustment knob. • Remove adjustment knob and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor. • Pivot seat upward and remove from the cardboard pack- ing. -
Page 8: Operation
These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. REVERSE NEUTRAL ENGINE OFF REVERSE OPERATION SYSTEM (ROS) LIGHTS ON BATTERY FUEL ATTACHMENT ATTACHMENT CLUTCH ENGAGED CLUTCH DISENGAGED FREE WHEEL (Automatic Models only) Failure to follow instructions could result in serious injury or death. -
Page 9: Know Your Tractor
KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. Our tractors conform to the applicable safety standards of the American National Standards Institute. (A) ATTACHMENT LIFT LEVER - Used to raise, lower, and adjust the mower deck or other attachments mounted to your tractor. -
Page 10: How To Use Your Tractor
The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. -
Page 11: To Move Forward And Backward
TO MOVE FORWARD AND BACKWARD (See Fig. 8) The direction and speed of movement is controlled by the gearshift lever (J). Fig. 8 1. Start tractor with clutch/brake pedal depressed and gearshift lever in neutral position. 2. Move gearshift lever to desired po si tion. 3. -
Page 12: Before Starting The Engine
TO STOP MOWER BLADES • Disengage at tach ment clutch con trol. CAUTION: Do not operate the mower without either the en tire grass catcher, on mowers so equipped, or the deflector shield (S) in place (See Fig. 10). Fig. 11 TO OPERATE ON HILLS CAUTION: Do not drive up or down hills with slopes great er than 15°... -
Page 13: To Start Engine
TO START ENGINE (See Fig. 4) When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine. • Sit on seat in operating position, depress clutch/brake pedal and set parking brake. -
Page 14: Maintenance Schedule
MAINTENANCE SCHEDULE Check Brake Operation Check Tire Pressure Check Operator Presence & ROS Systems Check for Loose Fasteners Check/Replace Mower Blades Lubrication Chart Check Battery Level Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness ck V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) Change Engine Oil (without oil filter) Clean Air Filter... -
Page 15: Blade Care
TRACTOR Always observe safety rules when per form ing any main te nance. BRAKE OPERATION If tractor requires more than five (5) feet to stop at highest speed in high est gear on a level, dry concrete or paved surface, then brake must be checked and ad just ed. (See “TO CHECK BRAKE”... -
Page 16: Transaxle Maintenance
BATTERY Your tractor has a battery charging system which is suf fi cient for normal use. However, periodic charging of the battery with an automotive charger will extend its life. • Keep battery and terminals clean. • Keep battery bolts tight. •... -
Page 17: Clean Air Screen
ENGINE COOLING SYSTEM (See Fig. 17) Debris may clog the engine's air cooling system. Remove blower housing and clean the area shown to prevent over- heating and engine damage. AIR SCREEN CLEAN OUT CHAFF AND DEBRIS Fig. 17 AIR FILTER Your engine will not run properly using a dirty air filter. -
Page 18: To Install Mower
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. •... -
Page 19: Service And Adjustments
SERVICE AND ADJUSTMENTS • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with retainer spring. • Repeat on opposite side of tractor. Fig. 20 • ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin (D) on rear mower bracket and secure with washer and... - Page 20 SERVICE AND ADJUSTMENTS TO LEVEL MOWER Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.
- Page 21 SERVICE AND ADJUSTMENTS TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 29) The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake. BELT REMOVAL - • Remove mower from tractor (See “TO REMOVE MOW ER”...
- Page 22 SERVICE AND ADJUSTMENTS TRANSAXLE GEAR SHIFT LEVER NEU TRAL ADJUSTMENT (See Fig. 31) The transaxle should be in neutral when the gear shift lever is in neutral (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows: •...
-
Page 23: Interlocks And Relays
SERVICE AND ADJUSTMENTS REPLACING BATTERY (See Fig. 34) WARNING: Do not short battery ter mi - nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. -
Page 24: Storage
Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more. WARNING: Never store the trac tor with gas o line in the tank inside a building where fumes may reach an open flame or spark. -
Page 25: Trou Ble Shoot Ing
TROUBLESHOOTING POINTS PROBLEM CAUSE 1. Out of fuel. Will not start 2. Engine not “CHOKED” properly. 3. Engine flooded. 4. Bad spark plug. 5. Dirty air filter. 6. Dirty fuel filter. 7. Water in fuel. 8. Loose or damaged wiring. 9. -
Page 26: Trou Ble Shoot Ing
TROUBLESHOOTING POINTS PROBLEM CAUSE 1. Faulty operator-safety presence control Engine continues system. to run when oper- ator leaves seat with attachment clutch engaged 1. Worn, bent or loose blade. Poor cut - uneven 2. Mower deck not level. 3. Buildup of grass, leaves, trash under mower. 4. -
Page 28: Warranty
The Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects in materi- als and work man ship. For a period of two (2) years from date of purchase by the original consumer purchaser, we will repair or replace, at our option, without charge for parts or labor incurred in replacing parts, any part which we find to be defective due to materials or workmanship.
Need help?
Do you have a question about the Poulan XT PXT12530 and is the answer not in the manual?
Questions and answers
How do I start it
To start the Poulan Pro XT PXT12530:
1. Move the throttle control to the choke position.
2. Insert the key into the ignition.
3. Turn the key clockwise to the "START" position and release it as soon as the engine starts. Do not run the starter for more than 15 seconds per minute.
4. If the engine does not start:
- Move the throttle to the fast position, wait a few minutes, and try again.
- If it still doesn't start, move the throttle back to choke and retry.
For warm weather starting (50°F and above):
- Once the engine starts, move the throttle to the fast position.
- The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and let it warm up.
This answer is automatically generated