Panasonic EP-MR30 Operating Instruction page 11

2
Move and install the unit.
Since the unit is very heavy (approx. 46 kg: including cushion, pillow and controller), be careful to avoid back injuries.
(The unit must be carried by two people.)
Put the unit down slowly and carefully watch around your feet.
CAUTION
• Do not drag or push the unit in an installed state.
• Placing a mat or cloth under the unit is recommended to prevent floor damage.
• Do not move the unit while someone is seated in it.
Failure to observe this precaution may result in accident or injury due to the unit tipping over.
Using the wheels to move the unit
Move the unit by holding the both sides of the footrest
firmly and lifting it no higher than waist height.
3
Attach the pillow and adjust the position.
You can raise or lower the pillow position using the belts
on the pillow.
• Align the hook-and-loop fastener on the back side of
the cushion with the hook-and-loop fastener on the
unit.
• Both the unit and the cushion have hook-and-loop
fasteners.
Wheels
Mat
Floor
How to Attach the Cushion to the Unit
• Attach the cushion so that it is aligned with the side of
the unit.
Transmission could be hampered if a receiver is
covered.
Hook-and-loop
fasteners
Lifting the unit
• Move the unit by having two persons lift it.
• Move the unit by having a person on each side
hold the areas shown in the diagram below.
• You may damage the floor by dropping the unit
if you do not hold it correctly.
Belt
Buckle
BEFORE USE
Belt
Buckle
Do not cover the
receivers.
GB10