Adding User Codes - TRU-BOLT 08102017 User Manual

Locking and Unlocking
TO LOCK THE LOCK
Using Keypad: Press
TO UNLOCK THE LOCK
Using Keypad: Enter a valid User Code (default code is 1234) and press
1 beep and lights green.
Changing Programming Code
CHANGE CURRENT OR PRESET PROGRAMING CODE
Factory default Programming Code
All programming functions require this code. Follow the below sequence to change the
Programming Code
PC
Hear 1 beep and Light Indicator illuminates green.
Record New and Changed Codes on Programming Record located on Page 19 & 20.
NOTE: When a NEW PROGRAMMING CODE is set, the default factory code (123456) is
deleted for safety.

Adding User Codes

TO ADD A NEW USER CODE (you can add up to 50 new user codes)
The User Code
UC
a User ID (which is any number between 01-50) to identify an individual User Code
ID
(User ID 1-9 should be entered as 01-09 so they are 2 digits).
ID
For example: to add the User ID - 08 to User Code - 5678, enter the following:
PC
123456, or new
Programming code
Hear 1 beep and Light Indicator illuminates green.
NOTE: When a NEW USER CODE is set, the default factory code (1234) is deleted
for safety.
Record New and Changed Codes on Programming Record located on Page 19 & 20.
and then hear 2 beeps and lights red.
PC
to your custom 6 digit combination.
PC
4 new
must be a 4-8 digit combination. Each User Code
1
ID
08
= 123456, this is the master password for your lock.
Re-enter
PC
6 digits
UC
5678
PC
PC
6 digits
is then linked to
UC
Re-enter
5678
and hear
.
UC
UC
Page 10