Anritsu Site Master S331L User Manual page 263

Instrument Messages
17. InstaCal Characterization data is corrupted: Characterization
data stored in the InstaCal module has been corrupted. Perform a
Factory Reset and then recycle the power to the instrument. If
error message persists, call your Anritsu Service Center.
18. Loading USB Sensor ... : The USB power sensor has been
detected and a connection is being established to this sensor.
19. Model Mismatch: When recalling a setup file or measurement file,
this message is displayed if the file being recalled was generated
by an instrument that is not the same model as the one being
used to recall the file.
20. Module Board Serial Number is corrupted: Serial number for the
Instacal/Power Meter module has been corrupted. Perform a
Factory Reset and then cycle the power to the instrument. If error
message persists, call your Anritsu Service Center.
21. PLL Lock failed: Phase Lock Loop hardware has failed to lock.
Perform a Factory Reset and then cycle the power to the
instrument. If error message persists, call your Anritsu Service
Center.
22. Power Meter Characterization data corrupted: Characterization
data stored in the power meter module has been corrupted.
Perform a Factory Reset and then recycle the power to the
instrument. If error message persists, call your Anritsu Service
Center.
23. Recalling File...Failed: An error was encountered while recalling
the file. The recall process was aborted. Try again. If the error
persists, the file may be corrupted.
24. Reverse relative not applicable: For the USB In-line power
sensor, relative readings do not apply when making reverse
measurements of Reflection Coefficient, Return Loss, or VSWR.
25. Saving File...Failed: An error was encountered while saving the
file. The save process was aborted. Check that the destination
location is accessible and try again. If the problem persists, the
current setup may have corrupted parameters or data. Preset the
instrument and try saving the file again.
26. USB drive missing. Please connect one to either USB port:
No USB flash drive was found while copying log files. Check that
the USB drive is installed correctly and try again.
S331L UG PN: 10580-00321 Rev. M
A-1 Introduction
A-3