Glue Bead Inspection; Settings Flow (Glue Bead Inspection) - Omron FH-3 Series Reference Manual

Glue Bead Inspection

Inspect the coated condition of coating (sealer, etc.). You can inspect coating of a specified color for gaps or
runoffs along the coating path. In addition to inspecting the above, you can also measure the maximum width,
minimum width and average of coating.
Used in the Following Case
• When you want to inspect coating for gaps and runoffs
Coating
Extrusion
Important
• Processing is different for color images and monochrome images. If the camera type, color camera, or monochrome
camera, was changed from a previous setup, a reset of some settings may be needed.

Settings Flow (Glue Bead Inspection)

Setting of coating gap inspection follows the flow shown below.
Make sure to set
Start
• For color cameras
Color Setting (Glue Bead Inspection)
• For monochrome cameras
Binarization (Glue Bead Inspection)
Region Setting (Glue Bead Inspection)
Measurement Parameters (Glue Bead Inspection)
Settings complete
Test measurement
494
Glue Bead Inspection
Gap
Max. width
Min. width
Set as necessary.
Output Parameters (Glue Bead Inspection)
Check results/make adjustments
FH/FZ5 Processing Item Function Reference Manual