Intake Shutter Valve; Intake Shutter Valve Actuator - Ford TRADER Workshop Manual

EXHAUST CONTROLLED HEATING SYSTEM
F2
9TGOF2·138
INTAKE SHUTTER VALVE
Inspection
1. Verify that the clearance at both sides of the valve is as speci-
fied when the valve is fully closed.
Clearance: 5.7 ± 0.2mm (0.224 ±
0.007
in)
2. If not as specified, adjust by turning the adjusting screw.
INTAKE SHUTTER VALVE ACTUATOR
Inspection
1. Remove the vacuum hose from the actuator.
2. Verify that the rod of the actuator moves smoothly when
moved by hand.
3. Start the engine and run it at idle.
4. Verify that there is vacuum at the vacuum hose. If not, check
the intake shutter valve solenoid valve.
(Refer to page F2-52.)
5. Install the vacuum hose, and verify that the actuator rod is
pulled.
Replacement
Note
• After installing the actuator, the vacuum warning
buzzer may ring until vacuum is built up.
1 . Disconnect the vacuum hose from the actuator.
2. Remove the C-clip.
3. Remove the actuator.
4. Install in the reverse order of removal.
Tightening torque:
7.8-11
N-m
(80-110
em-kg,
69-95
in-Ib)
F2-S1