Troubleshooting Cycle Faults - SciCan STATIM 5000 Service Manual

3. Troubleshooting Cycle Faults

Troubleshooting Cycle Faults
There are three types of cycle fault formats that can be seen on all STATIM 2000 and 5000 Classic
and G4 units. They are as follows:
1. Cycle fault numbers and descriptions appropriate to ONLY STATim 2000 non S units with
revision 3.x and 4.x type controller boards.
• Typically, these will show a number preceded by "Check Cassette".
• T he display on the LCD screen will NOT show any software revision and will display
"SELECT A PROGRAM" when switched on.
2. Cycle fault numbers and descriptions appropriate to ALL STATim 2000 and 5000 units with
revision 2.x/5.x/6.x and 7.x type controller boards with revision 1.xx/2.xx/4.xx/5.xx and 6.xx
software as appropriate.
• These units will show a number preceded by "CF".
• W hen the unit is switched on, a software revision number will be displayed for a short
time on the top, right hand side of the LCD display (for example S2S2R415), depending
on type (2000/5000), model (S or non S) and controller type.
3. Cycle fault descriptions only with no fault number. These are generic faults that do not
necessarily occur as the result of a mechanical or electrical failure of the STATim unit but of a
process error.
After identifying the unit you are trying to diagnose, refer to the following troubleshooting guides
to assist in the diagnosis.
STAT IM 2000/2000S
STATIM 5000/5000S/5000 G4 Service Guide
Service Guide
96-106775 Rev 5.0
Page 65