Procedure; Electrical Installation; Overview; Quick Install - GE D485 Instruction Manual

GE
Grid Solutions

PROCEDURE

OVERVIEW

D485 MODBUS TO DEVICENET CONVERTER – USER GUIDE
D485 Modbus to DeviceNet
Converter
Chapter 2: Installation
Installation

Quick install

1. Snap the D485 on to the DIN-rail (see DIN-rail mounting on page 2–5).
2. Connect the
DeviceNet
3. Connect the serial Modbus network cable (see Modbus connector on page 2–4 for
details).
4. Connect a PC using the configuration cable (see Configuration cable on page 2–3).
5. Connect the power cable and apply power to the unit (see Power connector on page
2–4 for details).
6. Start the EnerVista P485/D485 Setup software.
7. Normally, the EnerVista P485/D485 Setup detects the correct serial port. If this does
not occur, select the correct port through the Port menu item.
8. Configure the D485 using EnerVista P485/D485 Setup and download the
configuration to the unit.
9. Configure and power-up the Modbus network device for communication.

Electrical installation

The location of the various electrical connectors is shown below.
cable (see DeviceNet connector on page 2–2).
2–1