Table of Contents
Advertisement
25
TRACK BALL
26
LEFT BUTTON
27
RIGHT BUTTON
*1: Effective only when optional radar overlay kit is installed.
*2: Effective only when the equipment is linked to auto pilot.
(2) LCD brilliance control
The screen's brightness can be adjusted by using the brilliance control on the display panel.
By keeping the brilliance control pressed, the screen's brightness will be adjusted to an optimal
condition automatically.
• JAN-701B
• JAN-901B
Note:
• For JAN-901B, pressing the brilliance control will automatically adjust the screen's brightness to an
optimal condition.
When the adjustment is completed, "AUTO ADJUSTMENT COMPLETE" will appear on the display.
Press the brilliance control again to erase the indication.
This equipment can be operated both from the Operation panel and the display.
2 Names and Functions
Table 2.1 Names and Functions-- Continued
The trackball is used to move the cursor on the screen for position
designation, selection of buttons on the display panel, menu
designation, etc.
Used for selecting a button, menus and options on the screen.
Pressing the left button is written as "left-click" in this book.
Used for confirming alarms.
Pressing the right button is written as "right-click" in this book.
2-4
Brilliance control
Brilliance control
Advertisement
Table of Contents
Need help?
Do you have a question about the JAN-701B and is the answer not in the manual?
Questions and answers
My ecdis jrc 7201 after shutdown and power on the start menu like navigation and planning not appear screen is blank.what to do?
If the JRC JAN-701B ECDIS screen is blank and the start menu does not appear after power on, check the following:
1. Ensure the power switch is turned ON.
2. If the monitor has malfunctioned, contact a JRC sales representative for repair.
3. Verify that the video cable is properly connected. If not, contact a JRC sales representative for repair.
4. If the main unit has malfunctioned, contact a JRC sales representative for repair.
This answer is automatically generated
My ECDIS JAN-701B is not showing the parallel index. How can I enable it? I can't find the instructions in my onboard manual. Any help or suggestions?