Table of Contents
Advertisement
Context Menu
Right-clicking when editing a graphic will display a shortcut menu. One of the menus below will
be displayed, depending on the operation state when right clicking.
(It is set to some cursor mode.)
Context Menu (The item which is common with the other operation)
Main Menu
Abort
S-57/C-MAP/ARCS Information
Other Information
Zoom Area
Dropped EBL/VRM
CCRP EBL/VRM
Running Fix / Remove Running Fix
High Resolution Area
Load Low Resolution
Select Chart Under Cursor
Change Active Panel
Note and Diagram
(A cursor mode is not set.)
Submenu
EBL1/VRM1
EBL2/VRM2
EBL1
EBL2
VRM1
VRM2
Move Origin1
Move Origin2
EBL1/VRM1
EBL2/VRM2
EBL1
EBL2
VRM1
VRM2
4-35
Reference
3.1.1.3
3.13
3.13
3.5.1
3.15.2.2
3.15.2.2
3.15.2.3
3.15.2.3
3.15.2.4
3.15.2.4
3.15.2.5
3.15.2.5
3.15.2.6
3.15.2.6
3.15.2.7
3.15.2.7
3.15.2.8
3.15.2.8
3.16
3.10.1
3.10.6
3.10.3
3.10.5
3.10.8
4 Route Planning
ECDIS
Advertisement
Table of Contents
Need help?
Do you have a question about the JAN-701B and is the answer not in the manual?
Questions and answers
My ecdis jrc 7201 after shutdown and power on the start menu like navigation and planning not appear screen is blank.what to do?
If the JRC JAN-701B ECDIS screen is blank and the start menu does not appear after power on, check the following:
1. Ensure the power switch is turned ON.
2. If the monitor has malfunctioned, contact a JRC sales representative for repair.
3. Verify that the video cable is properly connected. If not, contact a JRC sales representative for repair.
4. If the main unit has malfunctioned, contact a JRC sales representative for repair.
This answer is automatically generated
My ECDIS JAN-701B is not showing the parallel index. How can I enable it? I can't find the instructions in my onboard manual. Any help or suggestions?