Chicco Fit 2 Instructions

Hide thumbs Also See for Fit 2:

INSTRUCTIONS:

IMPORTANT: Please also refer to the instructions that came with your product.

Rotate the Carry Handle up into the carry position.

Press the button on the Canopy Mount and remove the

Canopy. Then rotate the Carry Handle back into

stationary position. Refer to User Guide if needed.

Press the Harness Adjuster Button and loosen the

Harness Straps and then undo the buckle and chest clips.

Remove the optional Head Rest Insert and Newborn

Positioner. Refer to User Guide if needed.

WARNING: Avoid serious injury or death to your child. Never

use your Fit 2 Child Restraint without the softgoods in place. You

must read and understand the Softgood Removal instructions and

the instructions in the User Guide. If you do not understand these

instructions, DO NOT attempt to remove the softgoods, STOP

and call Chicco at 1-877-424-4226.

Fit 2 Softgood Removal

the Comfort Kit.

through the slot on the BACK of the Harness Buckle. Then

pull Tab out of the FRONT and remove Crotch Strap Pad.

IMPORTANT! If Crotch Strap Pad prevents harness from properly

fitting small Infant, it should be removed.

into the lowest position. Refer to User Guide if needed.

Undo the hook and loop fasteners on BOTH sides of

Remove the Crotch Strap Pad by pushing the fabric Tab

Remove the Shoulder Pads. Then adjust the Head Rest

SS0002.A.E

Table of Contents

Need help?

Do you have a question about the Fit 2 and is the answer not in the manual?

Page 1 WARNING: Avoid serious injury or death to your child. Never use your Fit 2 Child Restraint without the softgoods in place. You must read and understand the Softgood Removal instructions and the instructions in the User Guide. If you do not understand these instructions, DO NOT attempt to remove the softgoods, STOP and call Chicco at 1-877-424-4226.
Page 2 Adjust Head Rest into the highest position. Then pull Flip the Carrier over and remove BOTH Shoulder Harness down on and un-tuck the bottom fabric pocket from the Straps from the Splitter Plate. Then flip the Carrier upright Head Rest Back Plate. and pull the Shoulder Harness Straps to front of Carrier.
Page 3 TO RE-ATTACH THE FABRIC: Thread Comfort Flex pads through the seat pad. Adjust On the top of the Carrier, fold the plastic tab under the Head Rest to lowest position and place the seat pad onto the fabric and tuck it into the Carrier frame. Press down firmly. A Carrier shell.
Page 4 Flip the Carrier over and push both fingers of the plastic tab into the correct slots, as shown. Fold the 2 plastic tabs under the edge of the Carrier WARNING - Make sure the pad and all attachment tabs do not shell.
Page 5 Attach hook and loop parts together before washing. Hang to dry. DO NOT BLEACH. Please consult your product manual for additional care and maintenance instructions. Contact Chicco Customer Service at 1-877-424-4226 for assistance in removing or replacing the softgoods.