Wiring Connection - JVC PANDORA KD-X241 Instruction Manual

INSTALLATION/CONNECTION

Wiring connection

JVC Amplifier * 1
Signal cord (not supplied)
Fuse (10 A)
Remote wire
(not supplied)
Ignition switch
Car fuse block
Separate red wire
Make this connection if your vehicle
factory wiring harness does not
have "12 V ignition switch" wire.
Rear/Subwoofer ouput
Light blue/yellow
To the steering wheel
remote control adapter
Join the same color wires together.
Blue/white: Remote (12 V 350 mA)
Orange/white: Illumination
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker (right)
Gray/black
White: Front speaker (left)
White/black
Purple: Rear speaker (right)
Purple/black
Green: Rear speaker (left) * 2
Green/black * 2
Antenna terminal
Blue: To power antenna
Blue/white: To amplifier
(Not used)
IMPORTANT
We recommend installing the unit with a
commercially available custom wiring harness specific
for your car and leave this job to professionals for your
safety. Consult your car audio dealer.
Vehicle
dashboard
Factory wiring
harness (vehicle)
Custom wiring harness
(separately purchased)
Brown
* 1
Firmly connect the ground
wire of the amplifier to
the car's chassis to avoid
damaging the unit.
* 2
You can also connect a
subwoofer speaker directly
using this lead without
an external subwoofer
amplifier. For setting, 13.
Recommended connection
ENGLISH
19