Install Ac Power Cord 9.5" Chassis; Install Additional Blades 9.5" Chassis; Apply Power To The 9.5" Chassis - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
back side of the chassis to an electrical service ground (such as a cold
water pipe).
Figure 3-67 CHS2U GW Chassis (Rear View)
2.8.1

Install AC Power Cord 9.5" Chassis

Locate the supplied AC power cord and attach to the AC Inlet located
on the back of the chassis [refer to
(Rear View)].
2.8.2

Install Additional Blades 9.5" Chassis

Refer to Chapter
4-3.
2.8.3

Apply Power to the 9.5" Chassis

Refer to Chapter
Figure 3-67 CHS2U GW Chassis
5, 2.1 Installation and Safety Precautions on page
5, 2.6 Powering Up the SV8100 on page 4-9
Issue 7.0
3 - 55