Panasonic KX-TDA100 Installation Manual page 186

3.3 Installation of the KX-TDA Maintenance Console
File Transfer PC to PBX (SD Card)
File Transfer PBX (SD Card) to PC
SD Card File View and Load
SD Card File Delete
Message File Transfer PC to PBX
Message File Transfer PBX to PC
Error Log
T1/E1 Signaling Bit Monitor
T1/E1 Line Trace
ISDN Protocol Trace
Digital Trunk Error Report
CS Information
PS Information
Timed Update
System Reset
Reset by the Command
186 Installation Manual
The programme files in the PC are transferred to
SD Memory Card of the Hybrid IP-PBX.
Programme files in the SD Memory Card is
overwritten in this process.
The programme files in the SD Memory Card are
transferred to the PC.
The name, date, time, and size of programme
files in the SD Memory Card are viewed, then
these files are transferred to each optional
service card in the Hybrid IP-PBX.
The programme files in the SD Memory Card are
deleted.
The message files for Outgoing Messages in the
PC are transferred to all MSG cards mounted on
the OPB3 card of the Hybrid IP-PBX. Available
only when at least 1 MSG card is installed.
The message files for Outgoing Messages in the
MSG cards mounted on the OPB3 card are
transferred to the PC. Available only when at
least 1 MSG card is installed.
The error log is displayed (for details, refer to
"4.1.5 Troubleshooting by Error Log").
Monitors the sent and received signalling bits on
T1/E1 line.
Traces the sent and received signalling bits and
dialling numbers on specified channel of T1/E1
line.
Displays ISDN protocol trace data of the BRI/PRI
card.
Displays the errors on digital trunks that are
collected in the past for selected time units (10
min, 30 min, 1 h, or 24 h).
Displays the internal information of the CS.
Displays the registration information of the PS.
Updates the programmes in the LPR cards
(optional service cards with local processors)
when newer programmes are found in the SD
Memory Card by comparing them at a preset
time. (During the update, the cards become out
of service.)
Resets the connected Hybrid IP-PBX. (It is the
same as pushing the Reset Button with the
System Clear Switch in the "NORMAL" position.)
After using this command, you have to restart the
KX-TDA Maintenance Console and connect to
the Hybrid IP-PBX again.