Stubborn Cleanup; Cleaning The Nutribullet Balance Power Base & Scale - NUTRIBULLET BALANCE User Manual

WARNING:
DO NOT WASH THE BLADES IN THE DISHWASHER. THE NUTRIBULLET BALANCE CUPS
CAN BE WASHED IN THE DISHWASHER BUT ONLY ON THE TOP RACK USING THE
NORMAL (NOT SANITIZE) CYCLE. THE NUTRIBULLET BALANCE CUPS AND BLADES
SHOULD NOT BE IMMERSED IN BOILING WATER FOR ANY REASON AS THIS WILL
WARP THE PLASTIC AND DAMAGE THE GASKETS.

Stubborn Cleanup

If ingredients dry inside the NutriBullet Balance, make your cleanup a snap by filling the cup
about 2/3 full with room temperature soapy water and screw on the Extractor Blade. Place
the cup assembly on the NutriBullet Balance, power base for about 20-30 seconds. This will
loosen the stuck ingredients, and with a light scrub, you'll be all done.
CLEANING THE NUTRIBULLET BALANCE POWER BASE & SCALE
For the most part the power base doesn't really get dirty, but if you neglect to twist the
blade on to the cup tightly, liquids can leak out and get into the base and activator buttons.
If this happens please use the following cleaning instructions.
Step 1: The most important thing is to UNPLUG the power base before cleaning!
Step 2: Make sure the blade is not attached to the power base.
Step 3: Remove the Smart Nutrition Sensor from the power base.
Step 4: Wipe the Smart Nutrition Sensor with a damp cloth until clean.
Step 5: Wipe the well in the bottom of the power base with a damp cloth until clean.
Step 6: Replace the Smart Nutrition Sensor by lining up the arrow on the Disc to the
arrow in the well of the power base. Gently press down until the disc is level.
NEVER SUBMERGE
SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
For more how-to information,
visit NutriBulletBalance.com