Allen-Bradley PowerFlex 750 Series Programming Manual page 318

Chapter 6 Troubleshooting
Event Fault/Alarm Text
No.
224 Port 4 Comm Loss
225 Port 5 Comm Loss
226 Port 6 Comm Loss
227 Port 7 Comm Loss
228 Port 8 Comm Loss
229 Port 9 Comm Loss
230 Port10 Comm Loss
231 Port11 Comm Loss
232 Port12 Comm Loss
233 Port13 Comm Loss
234 Port14 Comm Loss
244 Port 4 Cfg
245 Port 5 Cfg
246 Port 6 Cfg
247 Port 7 Cfg
248 Port 8 Cfg
249 Port 9 Cfg
250 Port 10 Cfg
251 Port 11 Cfg
252 Port 12 Cfg
253 Port 13 Cfg
254 Port 14 Cfg
264 Port 4 Checksum
265 Port 5 Checksum
266 Port 6 Checksum
267 Port 7 Checksum
268 Port 8 Checksum
269 Port 9 Checksum
270 Port10 Checksum
271 Port11 Checksum
272 Port12 Checksum
273 Port13 Checksum
274 Port14 Checksum
281 Enet Checksum
282 DLX Checksum
290 Prev Maint Reset
291 HSFan Life
292 InFan Life
293 MtrBrng Life
294 MtrBrng Lube
295 MachBrng Life
296 MachBrng Lube
307 Port7InvalidCard
308 Port8InvalidCard
310 Regeneration OK
315 Excess Psn Err
318 OutCurShare PhU
319 OutCurShare PhV
320 OutCurShare PhW
318
Type Fault Configuration
Action Parameter
Resettable Fault Coast
Alarm 2
Resettable Fault Coast
Resettable Fault Coast
Resettable Fault Coast
Alarm 1
Configurable 493 [HSFan EventActn]
Configurable 500 [InFan EventActn]
Configurable 506 [MtrBrngEventActn]
Configurable 510 [MtrLubeEventActn]
Configurable 515 [MtrBrngEventActn]
Configurable 519 [MchLubeEventActn]
Non-Reset Fault Coast
Non-Reset Fault Coast
Resettable Fault Coast
Configurable Configured with Logix
controller.
Alarm 1
Rockwell Automation Publication 750-PM001N-EN-P - February 2017
Auto Description/Action(s)
Reset
The device at the port has stopped communicating with the main
control board.
Verify that the device is present and functional.
Verify network connections.
Verify options that are installed in ports 4...8 are seated in the port
and secured with mounting screws.
The main control board does not have the correct option in the port.
Option may not be compatible with product or MCB firmware must be
updated to support it. Option may have to be moved or removed,
accept option configuration change.
An option module storage checksum failed.
Option data has been set to default values.
EtherNet/IP storage checksum failed. Data set to default values.
DeviceLogix storage checksum failed. Data set to default values.
Predictive maintenance function has reset an elapsed life parameter.
Predictive maintenance function has reached the event level. Perform
maintenance.
Option not valid in that port. Remove option module.
The drive has detected that the 'Regeneration OK' input has transition
to an 'inactive' state.
The absolute maximum Position Error value has been exceeded.
There is output current sharing imbalance between parallel inverters
in the phase indicated that is greater than 15 % of the inverter rated
current.