4.4
REMOVAL AND REPLACEMENT PROCEDURES
This section describes the part removal procedures for the
Model FD1165.
The replacement procedures are the reverse
of the removal procedures, unless noted.
ments are included with the removal and replacement proce
dures.
If electrical adjustment is required after replace
ment, a reference is given to the appropriate section of
Chapter 5.
4.4.1
PCB Removal
Use the following procedure to remove the PCB.
a.
Disconnect all the connectors from the PCB.
b.
Remove the four screws that hold the PCB to the base
frame.
c.
Lift the PCB out of the base frame.
Table 4-2
Maintenance Parts
4-2
Mechanical adjust