Table of Contents
Advertisement
To use the detector:
1. Activate the RF Remote/Detector with the keypad RF Remote/Detector Power On/Off button
. You will hear a single beep, and icons in the lower portion of the LCD will be displayed,
showing all available options. This confirms that the unit is activated, but the lasers and
detector have not been turned on. You can now turn on the lasers and the detector.
X
Y
RF Remote/Detector activated
2. Turn on the level and/or plumb laser
keypad. (See the Operating Modes section.). As soon as one or both of the lasers are turned
on, icons displayed will confirm the laser (level, plumb, or both) and mode (Spin or Line
Dither/Scan) selected. Both the level and plumb lasers start up in Spin mode, at the slowest
speed.
Y
Plumb laser, Spin mode, Detector Off
Note: The LCD display only shows the laser modes for commands transmitted to the laser
tool from the RF remote control. Any commands made from the base unit controls will not be
shown on the RF remote control/laser detector LCD.
Press the plumb or level Laser On/Off button again to switch to Line Dither/Scan mode.
Y
Plumb laser, Line Dither/Scan mode, Detector Off
X
Level laser, Line Dither/Scan mode, Detector Off
and make any other selections desired from the
X
Level laser, Spin mode, Detector Off
9
RT-7690-2 User Guide
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the RT-7690-2 and is the answer not in the manual?
Questions and answers
Receiver not showing levels
The RoboToolz RT-7690-2 receiver may not be showing levels because the RF Remote/Detector has been activated but the lasers have not been turned on. After activating the detector, you must turn on the level and/or plumb laser for the detector to display level information. If the lasers are off, the detector will not show level data.
This answer is automatically generated