Table of Contents
Advertisement
Setup
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Place the Welder on a level surface that can bear its weight near the work
area. Leave space around the Welder for proper air flow.
TIg Setup
connect cables
1. Plug Ground Clamp cable into Positive Socket.
Twist clockwise all the way to lock in place.
2. Plug TIG Torch cable into Negative Socket.
Twist clockwise all the way to lock in place.
connect Strap
1. Thread end of Strap through slot on end of Welder.
2. Thread same end through bottom of buckle.
3. Repeat for other side.
4. Adjust Strap as necessary.
5. Pull on both ends of strap to make sure it is secure.
Page 8
TO pREVENT SERIOUS INJURy FROM AccIdENTAL OpERATION:
Turn the power Switch off and unplug the welder before set up.
Negative
Socket
For technical questions, please call 1-888-380-0318.
positive
Socket
Foot pedal
Socket
TIg
Torch
3. Plug Foot Pedal cable into Foot Pedal Socket.
Secure by turning collar clockwise until tight.
Foot
pedal
ground
clamp
Item 63618
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PROTIG 165 and is the answer not in the manual?
Questions and answers
I need the ground plug and clamp
The ground clamp cable for the Vulcan-Hart PROTIG 165 should be plugged into the Negative Socket of the welder. If you need a replacement, check with a qualified service provider or the manufacturer.
This answer is automatically generated