Hitachi FLASHMAX2 User Manual page 33

[If the SoftRAID function of the OS is used]
RAID must be configured in advance as described in
1. Modify the fstab file
Add the "/etc/fstab" entry to the file.
Add "noauto" to the mount options, and set dump and fsck to 0.
Example: /dev/md0 /mnt/flash_drive0 ext4 defaults,noauto 0 0
(device) (mount location (any)) (file system)
* Place a comma (,) not a dot (.) before noauto.
* Before modifying the fstab file, make sure a file system has been created on
the Flash Drive and the drive can be mounted manually.
2. Edit the vgcd.conf file
(1) Edit "/etc/sysconfig/vgcd.conf" and specify the mount point.
Specify the mount point defined in [ /etc/fstab] in [MOUNT_POINTS=""].
(2) Edit "/etc/sysconfig/vgcd.conf" and change "RESCAN_MD=1" to
"RESCAN_MD=0"
(1) " /etc/fstab " is defined as follows:
/dev/md0 /mnt/flash_drive0 ext4 defaults,noauto 0 0
MOUNT_POINTS= " /mnt/flash_drive0 "
(2) To mount multiple Flash Drives, place a space between the mount points. The
following example shows how to mount two Flash Drives.
mount /dev/md0 /mnt/flash_drive0
mount /dev/md1 /mnt/flash_drive1
MOUNT_POINTS= " /mnt/flash_drive0 /mnt/flash_drive1 "
PCIe Flash Drive FlashMAX2&3 User's Guide
Driver and Utility
For RHEL 6 on page 3-32.
3-17