Display Of Detailed Information On A Past Trip - Toshiba TOSVERT VF-nC3 Instruction Manual

(Continued)
Item displayed
Note 7 Parts replacement
alarm information
Cumulative
Note 8
operation time
Default display
mode
8.2.2
Details on a past trip (of trips 1 to 4) can be displayed, as shown in the table below, by pressing the center of the
setting dial when the trip record is selected in the status monitor mode.
Unlike the "Display of trip information at the occurrence of a trip" in 8.3.2, details on a past trip can be displayed,
even after the inverter is turned off or reset.
8
Item displayed
Note 9
Past trip 1
Continuous trips
Output frequency
Direction of
rotation
Frequency
command value
Note 2
Output current
Note 3
Input voltage
(Continued overleaf)
Refer to page H-8 for notes.
Panel LED
operated display
m }}}i

MODE 

Display of detailed information on a past trip

Panel
LED display
operated


6




Communic
ation No.
The ON/OFF status of each of the cooling fan,
circuit board capacitor, main circuit capacitor of
parts replacement alarm or cumulative operation
time are displayed in bits.
ON: 
OFF: 
FE79
m }}}i
Cumulative
operation time
The cumulative operation time is displayed.
FE14
(0.01=1 hour, 1.00=100 hours)
The output frequency is displayed (Operation at
60Hz).
Past trip 1 (displayed alternately)
For OCA, OCL, and Err5, the number of times (maximum of
31) the same trip occurred in succession is displayed (unit:
times). Detailed information is recorded at the beginning
and ending numbers.
The output frequency when the trip occurred is displayed.
The direction of rotation when the trip occurred is displayed.
(: Forward run, : Reverse run)
The frequency command value when the trip occurred is
displayed.
The inverter output current when the trip occurred is
displayed. (%/A)
The inverter input voltage (DC detection) when the trip
occurred is displayed. (%/V).
H-4
E6581595
Description
Cooling fan
Control circuit board capacitor
Main circuit capacitor
Description