Troubleshooting - Sprada Future TS4 Operating Instructions Manual

6. TROUBLESHOOTING

6. TROUBLESHOOTING
FAULT
No hot water or steam
Not enough milk froth or
liquid froth
Coffee only drips
No "crema" on the coffee Unsuitable coffee beans
Strong noise from coffee
grinder
In the event of not being able to correct a fault or malfunction, or not being
able to clear a fault message, call a SPRADA customer service centre.
If the system detects any errors, the display will show an error report:
•
•
Attention: Please make a note of the flashing or lit bars. Switch the
!
machine off and pull the mains plug. Contact the service centre with
information regarding the machine type, serial number (see label, Fig.1/O)
and error number.
Our customer service centre will then advise you on how to proceed.
20
MEANING
Blocked steam/hot water spout/
frothing device (Fig.1/K)
System may be calcified
Unsuitable milk
Blocked steam/hot water spout/
frothing device
System may be calcified
Coffee is too finely ground
Coffee powder too fine
Beans may be too old
Grinding coarseness not adjusted
to suit the beans
Foreign matter in grinder e.g.
small stones
flashing bars or
lit bars
WHAT TO DO
Dismantle and thoroughly clean
à à
steam/hot water spout/frothing
device (Fig.2)
Run a high dosage of descaler
à à
(see point 4.3)
Use cold milk
à à
Dismantle and thoroughly clean
à à
steam/hot water spout/frothing
device (Fig.2)
Run a high dosage of descaler
à à
(see point 4.3)
Set the grinder to a coarser
à à
setting
Change to coarser
à à
powder
Change coffee beans
à à
Change to fresh beans
à à
Optimise grinding coarseness
à à
Call service centre, ground
à à
coffee can still be made
coffee