Table of Contents
Advertisement
Available languages
Available languages
DRAIN HOSE : FITTING INSTRUCTIONS
To avoid emptying the water container after each
drying cycle, the water can be discharged directly
to a waste water drain pipe (the same drainage
system as household sinks). Water Bye-Laws
prohibit connection to a surface water drain. The
waste water drain pipe should be located adjacent
to the tumble dryer.
The kit consists of:1 hose and 1 tap.
WARNING!
tumble dryer plug from the electricity supply
before carrying out any work.
Fit the Hose as Follows:
1.Flip the machine
slowly to the right side.
2. The waste water
pipe is situated at the
right-hand side of the
machine (see the
picture). A grey hose
connects to the bridge
at the left hand side of
the machine. Using
pliers, remove the pipe
retaining clip from the
bridge.
3. Pull the hose off the
bridge connection.
Switch off and remove the
4. Attach the black
hose from the kit,
(using the connector
a n d
p i p e
supplied), to the hose
removed from the
bridge connection.
5. Once the machine is
in place, check the
bottom to ensure that
the new hose does not
kink when pushing the
t u m b l e d r y e r i n t o
position.
6. Connect the new
drain hose to the waste
Water pipe.
7. Connect to the
m a i n s e l e c t r i c i t y
supply.
Caution: If the product
is in different side, wait
at least 4 hours before
switching on so that the
oil can flow back into
t h e c o m p r e s s o r .
Failure to do this could
result in damage to the
compressor.
0
8
EN
c l i p s
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Dynamic Next and is the answer not in the manual?
Questions and answers
Please can you give me cleaning instructions?
The cleaning instructions for the Hoover Dynamic Next washing machine are:
- Clean the filter and empty the water container after every drying cycle.
- Regularly clean the condenser.
- After use, wipe the inside of the drum and leave the door open to allow air circulation.
- Wipe the outside of the machine and the door with a soft cloth.
- Do not use abrasive pads or cleaning agents.
- To prevent door sticking or fluff buildup, clean the inner door and gasket with a damp cloth after every drying cycle.
This answer is automatically generated
I cannot find my manual
You can find a manual for the Hoover Dynamic Next by searching online for its model number along with the term "manual." Based on the provided context, manuals for different Hoover Dynamic Next models are available on websites like gebruikershandleiding.com and usermanuals.au.
This answer is automatically generated
How do I run a dry only program
To run a dry-only program on a Hoover Dynamic Next tumble dryer, select the desired drying program using the control dial. You can choose from various drying levels such as iron dry, hanger dry, wardrobe dry, or super dry. If you want to delay the start, use the delay start button to set the time in one-hour increments up to 24 hours. If your model supports NFC, you can also use the Hoover Wizard app to select and start a program.
This answer is automatically generated
Power on programme selected but not spinning I could hear the motor trying to spin but seems like it is jammed!!!
Your Hoover Dynamic Next washing machine may not be spinning due to one of the following reasons:
1. Spin is turned off – Check if the spin function has been disabled in the selected program.
2. Unbalanced or small load – If the load is too small or unbalanced, the machine may not spin properly. Try redistributing the laundry or adding more items.
3. Quick wash program – Some quick wash programs have limited or no spin cycles. Verify if a different program works.
4. Drain pump filter blockage – A clogged drain pump filter can prevent spinning. Clean the filter to ensure proper drainage.
Check these factors to resolve the issue.
This answer is automatically generated
I noticed that the outside of the tumble dryer was quite hot. Is this normal, I have not noticed it before.
Yes, it is normal for the outside of the Hoover Dynamic Next tumble dryer to become quite hot. The manual states that where the hot surface symbol is located, the temperature during operation may exceed 60°C.
This answer is automatically generated