Table of Contents
Advertisement
Available languages
Available languages
CONTROLS AND INDICATORS
Programme
Selector
Control Panel and Indicator Lights
SELECTING THE PROGRAMME
The Candy Sensor Dry machine gives many options for drying the laundry to suit all circumstances.
The table on the next page lists the programmes and the function of each programme.
Note:
The sensor may not detect a small load of small articles. For small loads and separate items or pre-
dried fabrics with low moisture content, use the timed programmes. If the sensor does not detect the
item the dryer will only operate for 10 minutes before going into cooldown. If the load is too large or
too wet to tumble dry the dryer will automatically go into cooldown after approximately 3 hours. In
these cases we advise to use a time cycles between 30 and 75minutes depending on the load size
and dryness required, and select high or low heat depending upon the fabric type.
Programme
Display
Time Selection
Button
The wool drying cycle of this machine has been approved by The Woolmark
Company for the drying of machine washable wool products provided that the
products are washed and dried according to the instructions on the garment label
and those issues by the manufacturer of this machine.
In UK, Eire, Hong Kong and India the Woolmark trade mark is a Certification
trade mark.
10 EN
Filter Care
Indicator
Acrylic Synthetic
Delay Start
Button
Button
Start/Pause
Button
Anti-Crease
Button
M1530
.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Dynamic Next and is the answer not in the manual?
Questions and answers
Please can you give me cleaning instructions?
The cleaning instructions for the Hoover Dynamic Next washing machine are:
- Clean the filter and empty the water container after every drying cycle.
- Regularly clean the condenser.
- After use, wipe the inside of the drum and leave the door open to allow air circulation.
- Wipe the outside of the machine and the door with a soft cloth.
- Do not use abrasive pads or cleaning agents.
- To prevent door sticking or fluff buildup, clean the inner door and gasket with a damp cloth after every drying cycle.
This answer is automatically generated
I cannot find my manual
You can find a manual for the Hoover Dynamic Next by searching online for its model number along with the term "manual." Based on the provided context, manuals for different Hoover Dynamic Next models are available on websites like gebruikershandleiding.com and usermanuals.au.
This answer is automatically generated
How do I run a dry only program
To run a dry-only program on a Hoover Dynamic Next tumble dryer, select the desired drying program using the control dial. You can choose from various drying levels such as iron dry, hanger dry, wardrobe dry, or super dry. If you want to delay the start, use the delay start button to set the time in one-hour increments up to 24 hours. If your model supports NFC, you can also use the Hoover Wizard app to select and start a program.
This answer is automatically generated
Power on programme selected but not spinning I could hear the motor trying to spin but seems like it is jammed!!!
Your Hoover Dynamic Next washing machine may not be spinning due to one of the following reasons:
1. Spin is turned off – Check if the spin function has been disabled in the selected program.
2. Unbalanced or small load – If the load is too small or unbalanced, the machine may not spin properly. Try redistributing the laundry or adding more items.
3. Quick wash program – Some quick wash programs have limited or no spin cycles. Verify if a different program works.
4. Drain pump filter blockage – A clogged drain pump filter can prevent spinning. Clean the filter to ensure proper drainage.
Check these factors to resolve the issue.
This answer is automatically generated
I noticed that the outside of the tumble dryer was quite hot. Is this normal, I have not noticed it before.
Yes, it is normal for the outside of the Hoover Dynamic Next tumble dryer to become quite hot. The manual states that where the hot surface symbol is located, the temperature during operation may exceed 60°C.
This answer is automatically generated