JVC RX-E112RSL Service Manual page 7

<Front panel assembly>
Removing the system control board with
power switch board
Prior to performing the following procedure, remove
the top cover and front panel assembly.
1. Remove the two screws A attaching the power
switch board.
2. Remove the eight screws B attaching the system
control board.
3. Disconnect the card wire from the connector CN401,
CN402 and CN412 on the system control board.
4. Remove the switch buttons and indicator esc., if
needed.
Removing the headphone jack board
Prior to performing the following procedure, remove
the top cover and front panel assembly.
1. Remove the screw C attaching the headphone jack
board to the front panel assembly.
(See Fig.1 to 3)
System control board
(See Fig.1)
RX-E112RSL/RX-E111RSL
Front panel assembly (inner side)
Power switch board
B
Headphone jack board
Headphone
jack board
Fig.1
Power switch board (forward side)
CN412
System control board (forward side)
Fig.2
Front panel assembly (inner side)
Indicator esc.
Switch button
Fig.3
B A
C
C
CN402 CN401
1-7