JVC NX-F3B Service Manual page 16

3.2 DVD mechanism
3.2.1 Removing the traverse mechanism
(See Fig.1 to 4)
(1) Remove the one screw A attaching the Front end board.
(See Fig.1)
(2) Remove the two screws B attaching the tramecha holder
from top side of DVD mechanism assembly. (See Fig.2)
(3) Remove the four screws C attaching the traverse mecha-
nism. (See Fig.3)
(4) Solder the solder part of DVD pick up. (See Fig.4)
(5) Disconnect the card wire from
DVD module board. (See Fig. 1)
Caution:
• Solder the short land section on the DVD pickup before dis-
connecting the card wire from the connector on the DVD
pickup. If the card wire is disconnected without attaching sol-
ders, the pickup may be destroyed by static electricity.
• When attaching the DVD pickup, be sure to remove solders
from the short land section after connecting the card wire to
the connector on the DVD pickup.
CN101
1-16 (No.MB662<Rev.003>)
CN101 and CN201
A
CN201
Fig.1
on the
Traverse mechanism assembly
C
B
Clamper base
B
DVD mechanism assembly
Fig.2
DVD mechanism assembly
Fig.3
Solder short land section
Fig.4
C