Network - Pioneer BDP-V6000 Operating Instructions Manual

Problem
The input does not switch
automatically on the Flat
Panel TV and AV system (AV
receiver or amplifier, etc.)
when playback is started on
the player or the Home Menu
or Home Media Gallery is
displayed.

Network

Problem
• BD-LIVE function
(connection to the Internet)
cannot be used.
• "Connection to the software
updating server failed" is
displayed when you try to
update the software.
"OK to grant network access
to BD applications?" is
displayed when a BD-LIVE
compatible disc is read.
Software updating is slow.
The player stops operating
while software is being
updated.
• "WRT NG ****" is displayed
on the front panel display
during software updating.
(**** meaning any
characters)
• "WRT FAILED" is displayed
on the front panel display
during software updating.
A message other than
"Network connection test
completed successfully" is
displayed when Connection
Test is performed.
Check
Is Display Power On set to
Off on the player?
Check
Is "LAN cable not connected"
displayed?
• Is "IP address cannot be
obtained." displayed?
• Is "No response from the
gateway." displayed?
Is "IP address is overlapped."
displayed?
Is the Ethernet hub (or router
with hub functionality)
operating properly?
Remedy
Set Display Power On to On (page 44).
Remedy
Perform Connection Test (page 49). If "Network connection test
completed successfully." is displayed, check the proxy server settings
(page 48). Also there may be a problem with the Internet connection.
Contact your Internet service provider.
• This is displayed for discs presenting security risks related to
connection to the Internet. Normally select No when this is displayed.
To allow connection to the Internet, select Yes.
• This may be displayed even if the disc does not support the BD-Live
function.
Depending on the Internet connection and other conditions, some time
may be required to update the software.
Software updating takes 10 to 20 minutes. Wait until updating is
completed. DO NOT turn the power off while the software is being
updated. Doing so may result in an operation failure.
The message is displayed when software updating has failed. Check
again whether it can be updated properly.
Check that this player and Ethernet hub (or router with hub
functionality) are properly connected.
• If the IP address is obtained using the DHCP server function, check
the setting is correct at the Display Network Configuration
(page 49). For details on the DHCP server function, see the operating
instructions of the Ethernet hub (or router with hub functionality).
• Set the IP address manually.
• Check the operation and settings of the DHCP server function of the
Ethernet hub (or router with hub functionality). For details on the DHCP
server function, see the operating instructions of the Ethernet hub (or
router with hub functionality).
• If this player's has been set manually, reset the IP address of this
player or other components.
• Check the settings and operation the Ethernet hub (or router with hub
functionality). For details, see the operating instructions of the Ethernet
hub.
• Reboot the Ethernet hub (or router with hub functionality).
09
71
En