Vane / Spread Widht - BOGBALLE M2 Operator's Manual

M2(W) / M3(W) / M6W

VANE / SPREAD WIDTH Setting
The vanes are mounted as standard in POS. 1-2
When mounting the fixing bolt must be pulled fully out
into the U-shaped cut before tightening the nut.
One vane in POS. 1
One vane in POS. 2
If in special cases it is
necessary to mount
the vanes
alternative position –
this will appear from
the spread chart in
question.
Vane "TYPE"

The spreading vanes are made in such a way that they are mounted in POS. 1-2, no
matter which type of fertiliser is used – and no matter which quantity is spread. This
means in practice that the spreading vane should only be "moved / demounted" in case
a calibration or emptying of the hopper is made.

Take care that the vanes are mounted and fixed correctly !
The vanes are TYPE- MARKED respectively:
"R" (Right)
"L" (Left)
 The vane TYPE is chosen in relation to the required spread width and/or fertiliser type.
Below is shown spread width / vane type for the main fertiliser types in the market.
If there are deviations from this it will appear on the spread chart in question.
VANE TYPE
Trend
(Normal / headland vane)
Trend
(Normal / headland vane)
Trend
(Normal / headland vane)
Trend
(Normal / headland vane)
Trend
(Normal / headland vane)
On each spreading disc
in an
For right spreading disc – seen from behind
For l
eft speading disc – seen from behind
E1T
E2T
E6T
E8T
U1T
POS. 1 - 2
V (L)
SPREAD WIDTH
12 – 18 metres
20 – 24 metres
28 – 36 metres
– 42 metres
12 – 18 metres
17
U- cut

POS.-
guidance is
shown on a label
fixed to the machine.
H (R)
E( )T-R
E( )T-L
MARK
E1T
R or L respectively
E2T
R or L respectively
E6T
R or L respectively
E8T
R or L respectively
U1T
R or L respectively