Quick Start; 5_First Steps; Battery; 1_Charging The Battery - DeWalt MD501 Quick Start Manual

10

5_first stEps

5.1_batteRy

The battery in this phone cannot be removed by the
The battery is not fully charged when the phone is purchased,
but it contains enough energy to power on the phone. To obtain
best battery performance and battery life, let the battery
discharge completely before charging it completely for the
fi rst three charging cycles.
Note
Because this phone has built-in battery, if the phone has
a fault and cannot be turned off, you can long press the on/off
button for 10 seconds to reset. This will restart the phone.
using the reset functionality may result in loss of unsaved data,
please use with caution!

5.1.1_chaRgiNg the batteRy

connect the uSB-cable with the phone
as indicated in the picture.
connect the plug with the socket
of the Power supply.
After charging, remove the uSB-cable
from the charger.

5.1.2_wiReLeSS chaRgiNg deviceS

The phone has integral wireless charging functionality,
supporting wireless chargers conforming to the QI standard.
Before using please read manufacturer's guidlines and this

QuIcK STArT

user.
QuIcK STArT
manual carefully, observing all safety
precautions and safe and proper use.
Do not expose the wireless charging
functionality to water, or microwave,
high pressure, high temperature or
inductive heating equipment.

5.1.3_batteRy USe

When the battery reaches a low battery level an alert will request
that the phone be charged. If this is not done immediately, un-
saved data may be lost. If the phone is left idle for long periods,
it will switched itself off.
waRNiNg
The phone's battery must be charged within the temperature
range of 5° c to 35° c! Please don't charge your phone outside
this temperature range, and please use the included uSB-cable.
The battery can only be replaced by the service center.
Note
Energy saving tips:
Turn off wireless communication function when
you use Bluetooth , Wi-fi or GPS.
® ®
reduce the screen brightness.
Turn off the screen when not using the unit.
Disable the automatic synchronization of emails,
calendars, contacts and other applications.
11
EN