HobbyKing HUMMER EPP-3D Instruction Manual

Before use, please read the explanations carefully!

HUMMER EPP- 3D

Instruction Manual

Specifications

Fuselage: Length 950mm

•

Wingspan: 1000mm

•

Flying Weight: 450 - 500g (with battery)

•

Additional Required Equipment (not included in the kit

•

Motor: 2212 1000KVor2213 1000KV

•

ESC: 20A

•

Propeller: 1047 Slow Flyer Prop

•

Servo: 4 * 9G

•

Radio::4/more channels 4

•

Battery: 11.1V 850-1300mAh li-po

•

1. We recommend that you get the assistance of an experienced pilot during the

assembling

process.

2. The kit contains small parts. So keep out of children's reach when assembling.

3. The flying weight of the plane is about 400g. In order to ensure the flight performance,

use the motor and battery with suitable weight.

Table of Contents

Do you have a question about the HUMMER EPP-3D and is the answer not in the manual?

Page 1: Instruction Manual
Before use, please read the explanations carefully! HUMMER EPP- 3D Instruction Manual Specifications Fuselage: Length 950mm • Wingspan: 1000mm • Flying Weight: 450 - 500g (with battery) • Additional Required Equipment (not included in the kit • Motor: 2212 1000KVor2213 1000KV •...
Page 2 P a r t s L i s t : Main wing (pair):1 • Fuselage: 1 • Stiffened of Fuselage (pair): 2 • Tail plane :1 • Rudder : 1 • Plywood Motor Mount ( set): 1 • Z-shaped steel wire : 8 •...
Page 3 4. Put 2 pieces of carbon rods with the length of 780mm into the slot of fuselage's stiffener, pay attention to the right and left direction. 5. Stick the stiffener to the body of aircraft with foam glue, the fuselage should keep straight.
Page 4 13. Put 2 pieces of long wood strip into the 330*4 slot. 14. Stick it with 502 glue. 15. Put the horizontal tail into the fuselage and stick them to make sure they are symmetrical. 16. Assemble the main aircraft wing and horizontal tail correctly, and make sure A=B as well C=D.
Page 5 25. Inset the head of fuselage then stick it with 502 glue. 26. Put landing gear steel wire into the hot shrink tube after it fixed with wheel, then stick the tube with 502 glue. 27. Insert the landing gear into the fuselage, then insert the wood stave into the se<am then stick with 502 glue.