Set Up A Wi-Fi Network For Airplay; Connect The Unit To A Wi-Fi Network (Router) - Philips Fidelio SoundCurve DS8800W User Manual

4 Set up a Wi-
Fi network for
AirPlay
Note
•
Some operations may vary as you use different types of
wireless routers.
•
You are recommended to change the SSID of your
wireless router to 'PhilipsFidelioAP'. In this way, the
unit can get connected to the router automatically
after power-on. You can hear a beep after successful
connection. Then, proceed to 'Connect an AirPlay
device to the same Wi-Fi network' directly.
The unit is compatible with the following iPod/
iPhone/iPad models:
• iPod touch (2nd, 3rd, and 4th generation)
• iPhone 4
• iPhone 3GS
• iPad 2
• iPad
Before setup of the Wi-Fi network, check
the points below.
1
Make sure that the wireless router is
powered on and working properly.
2
Make sure that the
of the main unit blinks in green slowly.
12 EN
indicator on the front
3
Check the type of the wireless router you
use.
Connect the unit to a Wi-Fi
network (router)
Select a scenario below that matches your
router type.
Note
•
Each time when the unit is powered on again, the
unit enters the latest configured Wi-Fi network
automatically.
•
In case of setup failure, repeat the steps, or press and
hold on the front of the main unit and try again.
Scenario 1: Connect to a WPS-PBC
router
1
Press WI-FI SETUP on the back of the
main unit.
»
The indicator blinks in red, green, and
yellow alternately.
2
Press the WPS button on the wireless
router.
»
After a while, the
blinking and stays green, and the
speaker beeps.
»
The unit joins the Wi-Fi network
successfully.
WIFI WIFI
WI-FI SETUP WI-FI SETUP
SETUP SETUP
indicator stops